Danfoss TS715 Si Manuel d'utilisateur télécharger pdf (Page 3)

Please Note:

This product should only be installed by a qualiﬁ ed

electrician or competent heating installer, and should be

in accordance with the current edition of the IEEE wiring

regulations.

Speciﬁ cation 230V Model 24V Model

Power supply 230 Vac, ±15%,

50/60 Hz

24Vac, ±15%,

50/60Hz

Switching action

1 x SPDT voltage free, Type 1B

Switch rating 24 - 230 Vac, 3(1)A

Battery back-up 24 hours minimum

Setting/Running Accuracy ±1 minute

Dimensions, mm (W, H, D) 135 x 88 x 32

Design standard EN 60730-2-7

Control Pollution Situation Degree 2

Rated Impulse Voltage 2.5kV

Ball Pressure Test 75°C

Product speciﬁ cation

Installation and Speciﬁ cation

Installation Instructions

Installation

 Remove wallplate from unit by unscrewing the two screws

on the bottom edge of the unit.



From the top left hand corner of the wallplate, there must

be clearances of at least 140 mm to the right, 15mm to the

left, 30mm above and 100mm below in order to mount

the plug-on module.

1 2 3 4 5 6 7 8 ... 31 32

Pas de commentaire

Danfoss TS715 Si Manuel d'utilisateur Page 3