Danfoss VLT 5000 FLUX Instructions d'exploitation télécharger pdf (Page 50)

VLT

5000 FLUX

Control Panel

(LCP)

■ Initialisation to factory setting

The frequency converter can be initialised to

factory settings in two ways.

nitialisation by parameter 620

- Recommended initialisation

• Select parameter 620

• Press [CHANGE]

• Select "Initialisation"

• Press the [OK] key

• Cut off the mains supply and wait until

the display turns off.

• Reconnect the mains supply - the frequency

converter is now reset.

This parameter initialises all except:

500 Serial communication address

501 Baud rate for serial communication

601-605 Operating data

615-617 Fault logs

Manual initialisation

• Disconnect from mains and wait until the

display turns off.

• Press the following keys at

the same time:

[Display/status]

[Change data]

[OK]

• Reconnecting the mains supply while

pressing the keys.

• Release the keys

• The frequency converter has now been

programmed for the factory setting.

This parameter initialises all except:

600-605 Operating data

NB!:

Settings for serial communication and

fault logs are reset.

MG.55.A7.02 - VLT is a registered Danfoss trademark

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 162 163

Pas de commentaire

Danfoss VLT 5000 FLUX Instructions d'exploitation Page 50