Danfoss C37 Guide de l'utilisateur télécharger pdf (Page 32)

The grey

side of the

ECL Card

Basic set-up

The controller can control the DHW temperature with either

one or two tank temperature sensor(s). The controller will

automatically register the number of sensors.

1 Cut-out temperature diﬀerence - (lower sensor)*

Circuit Setting range Factory setting

II 1 ... 99 K 15 K

Set the diﬀerence between the desired charging temperature and

cut-out temperature (charging stop) .

Set the diﬀerence.

Example:

Desired charging temperature (section 3): 60 °C

Cut-out diﬀerence: 15 K

Calculated cut-out temperature (60-15) = 45 °C

2 Cut-in temperature diﬀerence - (upper sensor)*

Circuit Setting range Factory setting

II 1 ... 99 K 20 K

Set the diﬀerence between the desired charging temperature and

cut-in temperature (charging start).

Set the diﬀerence.

Example:

Desired charging temperature (section 3): 60 °C

Cut-in diﬀerence: 20 K

Calculated cut-in temperature (60-20) = 40 °C

* In case of two sensors.

Cut-in and cut-out temperature

at DHW charging - lines 1-2,

circuit II

27a

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 77 78

Pas de commentaire

Danfoss C37 Guide de l'utilisateur Page 32