Danfoss ECtemp 535 Guide d'installation télécharger pdf (Page 8)

Do not place the thermostat in a way that

it will be exposed to direct sunlight.

Note: A floor sensor enables a more accu-

rate temperature control and is recom-

mended in all floor heating applications

and mandatory under wooden floors to

reduce the risk of over-heating the floor.

▪

Place the floor sensor in a conduit in an appropriate

place where it is not exposed to sunlight or draft

from door openings.

▪

Equally distant and >2cm from two heating cables.

▪

The conduit should be flush with the floor surface -

countersink the conduit if necessary.

▪

Route the conduit to the connection box.

▪

The bending radius of the conduit must be min

50mm.

ECtemp 535

8 Installation Guide

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Danfoss ECtemp 535 Guide d'installation Page 8