Danfoss ECtemp 535 Manuel d'installation télécharger pdf (Page 18)

Setting the timer periods

When programming the starting times of the 4

periods keep in mind that the thermostat will

start heating/stop heating at the given time.

Therefore some periods should start and end

before, to compensate for the time it takes to

heat up or down.

The ﬁrst period bar ﬂashes indi-cating this

is the morning period.

By pressing the • the start time of the period

starts ﬂashing. You change it with the arrow

buttons ▲▼ in increments of 15 minutes.

Press the • to accept

The second period bar ﬂashes indicating

this is the day period.

Setting it in the same way.

The third period bar ﬂashes indicating this

is the evening period.

Setting it in the same way.

The fourth period bar ﬂashes indicating

this is the night period.

Setting it in the same way.

Changing the settings

Note! When setting the time periods you cannot step back-

ward to the previous time period, until the last one is set. This

is to ensure that the periods do not overlap.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Pas de commentaire

Danfoss ECtemp 535 Manuel d'installation Page 18