Danfoss ECtemp 535 Manuel d'installation télécharger pdf (Page 22)

Special features / Trouble shooting

Switching displayed temperature

Depending on what mode the thermostat is

installed as (ﬂoor, or a combination of ﬂoor and

room) you can change which temperature is

displayed.

If installed as a ﬂoor sensor system only, you can

change the displayed temperature from ﬂoor

sensor temperature to room sensor tempera-

ture, if you wish to use the thermostat as a

thermometer. You change the display by

pressing ▲ and ▼ at the same time for 2 seconds.

The room sensor icon is displayed.

You press them again to return to the default

display.

If installed as a combination thermostat, by

pressing ▲ and ▼ at the same time for 2 seconds,

the temperature in the ﬂoor sensor is displayed

for 2 minutes. The ﬂoor sensor icon is

displayed.

Clock symbol ﬂashing:

Time settings were lost due to power cut.

The thermostat resumes to manual mode.

Trouble shooting

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Danfoss ECtemp 535 Manuel d'installation Page 22