Danfoss ECtemp 535 Manuel d'installation télécharger pdf (Page 6)

3. Choose sensor combination

When installing the EFET™ 535 you need to choose

the type of heating and thus which sensors should be

used. You have three options:

Comfort heating: Constant temperature on the ﬂoor in

bathrooms and other rooms where a comfortable warm

surface is required.

Install the Floor sensor and choose only the Floor sensor.

Total heating: Control of room temperature in living

rooms etc. Install the Floor sensor and choose both

Floor sensor and Room sensor.

No ﬂoor sensor: A ﬂoor sensor is not present, and

cannot be installed. Choose Room sensor. (Not

recommended).

Be aware that without a ﬂoor sensor, the temperature

control can be less accurate, and overheating of the

ﬂoor is of higher risk.

Danfoss recommends that a ﬂoor sensor is always

installed.

When the thermostat is used to control a ﬂoor heating

element according to EN/IEC 60335-1 and

EN/IEC 60335-2-96, always use the ﬂoor sensor

and never set the temperature limit above 35°C.

Choose sensor combination

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Danfoss ECtemp 535 Manuel d'installation Page 6