Danfoss DLX 4.6 Guide de l'utilisateur télécharger pdf (Page 32)

32 User Guide DLX Series L00410623-1

4.3.6.1. Connection Procedures

Figure 4.3.30: Customer connection area with network terminals

1. CAN bus terminal

2. RS-485 terminal

3. Ethernet connector

4. Network cable gland

• Ethernet: Use CAT5e or better, with size 0.21 mm

/24 AWG, and a maximum total length

of 100 m.

• CAN: Use CAT5e or better, with size 0.21 mm

/24 AWG, with a maximum total length of

500 m.

• RS-485 Use CAT5e or better, with size 0.21 mm

/24 AWG, with a maximum total length

of 1200 m

• Unscrew the network cable gland, and take out the grommet.

• Three-way cable gland insert:

Figure 4.3.31: Insertion of network cables in gland

1. Conductors with connector: Cut through the grommet with a width of about 1mm.

With no connector no cutting is necessary

2. Remove the plug from inside the grommet.

3. Assemble the cable in the gap.

Repeat step 1 – 3 if more cables.

4. Guide the assembly into the cable gland.

5. Connect the cables to the terminals in the connection area as follows:

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Pas de commentaire

Danfoss DLX 4.6 Guide de l'utilisateur Page 32