Danfoss TripleLynx CN Manuel d'installation télécharger pdf (Page 202)

Solar-Log500: Configuration at the unit

Configuring the internet data (“Internet” menu)

202 of 268 Solar-Log

1000/500/200

Installation

9.6.5 Setting a password (Internet/Password)

Here you have to enter the password for the homepage to which SolarLog

500

is to transfer the data.

1 In the menu, select Internet/Password

2 Enter a password

3 Press ENTER to save

9.6.6 Intervals for transferring data to the homepage (Internet/Interval)

Here you enter the interval at which SolarLog

500

is to automatically send data

for the homepage.

1 In the menu, select Internet/Interval

2 Select the desired interval

(1 hr., 2 hrs., 4 hrs., 8 hrs. or once daily)

3 Press ENTER to save

9.6.7 Test transmission (Internet/Connection test)

The transmission test allows you to check whether the settings have been

made correctly and data transfers are working over the internet. The test

transmission only sends a small file, in order to reduce the transfer time and

therefore the waiting time.

1 Select Internet/Connection test from the menu.

2 Select Yes to start the test transmission

If a fault is detected, a fault code is displayed;  Page 253.

In this case, check the settings then repeat the test transmission as often

as necessary until an OK message is displayed.

3 Press ESC to end the test

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 267 268

Pas de commentaire

Danfoss TripleLynx CN Manuel d'installation Page 202