Danfoss TripleLynx CN Manuel d'installation télécharger pdf (Page 69)

Connecting the inverters

Conergy (only Solar-Log1000)

Solar-Log

1000/500/200

Installation 69 of 268

Connecting inverters to the Solar-Log

1000

Connection is only done using a ready-made data cable, specially for connect-

ing to the Solar-Log

1000

(optional extra; not supplied).

Procedure

1 Insert the CAN plug into the inverter CAN IN socket.

2 If only one inverter is to be connected it must be terminated:

Insert the two 5 pin 120 Ω terminal resistors from the ready-made cable set

into the CAN OUT socket.

3 Insert the terminal block connector into the Solar-Log

1000

CAN socket.

Connecting the inverters to each other (only Solar-Log

1000

)

 Connection is made only with a ready-made data cable specially for

connecting the inverters to each other (optional extra: not supplied).

 Where to connect: CAN socket outside the inverter

Procedure

1 Insert the CAN plug into any CAN OUT socket on inverter 1.

2 Insert the other end of the wire into any CAN IN socket on inverter 2.

3 Connect the other inverters to each other in the same way.

4 Terminate in the last inverter:

Insert the two 5 pin 120 Ω terminal resistors from the ready-made cable set

into the CAN OUT socket.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 267 268

Pas de commentaire

Danfoss TripleLynx CN Manuel d'installation Page 69