Danfoss TripleLynx CN Manuel d'installation télécharger pdf (Page 214)

Solar-Log1000: Configuration at the unit

Changing the network settings (Basic/Network)

214 of 268 Solar-Log

1000/500/200

Installation

 Internet access

– None

The Solar-Log

1000

can only be accessed locally, i.e. through a direct PC

connection or through a network router without internet access.

– Network router

The internet is accessed through an internet router. The internet router

must be connected to the network interface of Solar-Log

1000

. This router

handles all dialup accesses and data transfers over the internet. A DSL,

cable modem or wireless router can be connected.

The important thing is that internet dialup should always be possible

from the Solar-Log

1000

. The internet router should not be switched off,

otherwise ordinary messaging will no longer possible when there is a

fault and the homepage will not be correctly supplied with data.

– Analogue modem

Internet access is provided by the analogue modem package (Page 130)

and using an analogue telephone connection. This is configured in a later

dialogue box.

– GPRS modem

Internet access is provided by the mobile communications package

( Page 131) or in Solar-Log

1000

GPRS ( Page 13) through the mobile

phone network. This is configured in a later dialogue box.

Procedure

1 Enable the desired option

2 Touch the input boxes beside IP Address and Subnet Mask

 The virtual keyboard is opened.

3 Enter the relevant data and touch OK to confirm

4 Touch Save, then Next to go to the next dialogue.

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 267 268

Pas de commentaire

Danfoss TripleLynx CN Manuel d'installation Page 214